Ensemble

Syndicate content 28 

Often InterSystems technology architect team is asked about recommended storage arrays or storage technologies.  To provide this information to a wider audience as reference, a new series is started to provide some of the results we have encountered with various storage technologies.  As a general recommendation, all-flash storage is highly recommended with all InterSystems products to provide the lowest latency and predictable IOPS capabilities.

The first in the series was the most recently tested Netapp AFF A300 storage array.  This is middle-tier type storage array with several higher models above it.  This specific A300 model is capable of supporting a minimal configuration of only a few drives to hundreds of drives per HA pair, and also capable of being clustered with multiple controller pairs for tens of PB's of disk capacity and hundreds of thousands of IOPS or higher. 

0 1
0

comments

646

views

+ 3

rating

I have a service that takes a file and pass it through to the production .While I am passing the file through I get the file stream and set it to a variable within my message and the variable is of type %Ens.Strea

Last answer 22 June 2018 Last comment 29 June 2018
0 4
166

views

0

rating

++ Update: August 1, 2018

The use of the InterSystems Virtual IP (VIP) address built-in to Caché database mirroring has certain limitations. In particular, it can only be used when mirror members reside the same network subnet. When multiple data centers are used, network subnets are not often “stretched” beyond the physical data center due to added network complexity (more detailed discussion here). For similar reasons, Virtual IP is often not usable when the database is hosted in the cloud.

Network traffic management appliances such as load balancers (physical or virtual) can be used to achieve the same level of transparency, presenting a single address to the client applications or devices. The network traffic manager automatically redirects clients to the current mirror primary’s real IP address. The automation is intended to meet the needs of both HA failover and DR promotion following a disaster. 

Last comment 14 June 2018
0 7
1852

views

+ 11

rating

When defining a server connection in Atelier we are required to enter a username and password because these are mandatory fields in the dialog. However, if the /api/atelier web application definition on that server has only the "Unauthenticated" checkbox set in the section titled "Allowed Authentication Methods", then our Atelier connection will succeed even if we supply an invalid username and/or password.

Last comment 29 May 2018
0 3
278

views

+ 1

rating