User bio
404 bio not found
Member since May 23, 2019
Posts:
Replies:
Thank so much, Kimberly! Looks like that is one (very important) piece of the puzzle. I have the ST/SE's outputting every 10 records but it looks like the SegCount only counts one record at a time. For instance, there are 156 segments, including the ST & SE, and the SE count was 13. I'm going to have to dig into those EnsLib.EDI.X12.Document properties and see if anything there can help me. Really appreciate the nudge in the right direction!
Thanks,
Jason
Certifications & Credly badges:
Jason has no Certifications & Credly badges yet.
Global Masters badges:
Jason has no Global Masters badges yet.
Followers:
Jason has no followers yet.
Following:
Jason has not followed anybody yet.
I figured it out. I set up a memory variable that I would just accumulate all the SegCount amounts until the SE was ready to get outputted. When it was time to output the SE, I'd take the memory variable + 1 and it would get the correct segment count, then I'd clear the variable.
Thanks again for your help, Kimberly!