Replies

Hi Steve,

Thanks much for reporting this issue.  Would you please contact InterSystems Support (by emailing support@intersystems.com or calling +1 617-621-0700) so we can further investigate the issue and resolve it?

Regards,

Joan-marie

Hello José,

Would it be possible to provide further details on how you encountered this issue?  What platform you are on, what Atelier version you upgraded from, confirm Eclipse version, how you upgraded?  Any additional details are great appreciated.

Regards,
Joan-marie

Atelier will only work with Unicode servers. It does not support 8-bit servers.

Hi Nicki,

I have an update to my previous comment.  I have been able to reprodue the issue you reported.  Here are the steps I seemed to need to reproduce the issue:

- I made sure in Server Explorer there was a properly configured connection but the server associated with the connection is shutdown.

- I then select New > Atelier Project.  I entered the Project Name and selected the link Configure Server and entered new Connection Name,  Address, WebPort and Credentials for a new Connection

-Pressed Test Connection and confirmed I saw the message 'Connection succeeded'

-If I then press Finish and return to the New Atelier Project wizard I see the message you reported 'No namespaces reported by selected server'.

-I do find then that if from the Server drop down I have another properly configured server connection and select that and then select the connection I just configured I am then able to see the Namespaces. 

Would you mind my asking, do these steps to reproduce seem at all similar to your case?  If you have another properly configured connection configured in Server Explorer and toggle between that and the one you created can you then see your namespaces? 

I will report this to Development. 

 

Hi Nicki,

I tried to reproduce the "No namespaces reported by selected server" using the same Atelier version you are using (1.0.107).  I created a new valid server connection (as it looks like you did) and I selected to create a new Atelier project using this same connection.  I did see the message you reported immediately after I selected my server, but then shortly after the message changed to 'Select a namespace'.   Did you ever see the 'Select a namespace' message afterwards?